There will be different ports assigned to each switch to a bridge since one switch will have a WAN port. Use these commands on SwitchA and SwitchB: The following section contains configuration that is only relevant to CRS1xx/CRS2xx series switches.Īll switches in this setup require that ports are added to a bridge.
Some devices have a built-in switch chip, that supports VLAN switching, for such devices you should check the Switch-Router guide. :global plcBefore “6 -the placement of FW rules"Īdd chain=forward comment="Forward Sonos multicast traffic" dst-address=: CRS3xx series part of the guide can be used for any device, though for devices, that do not support hardware offloaded bridge VLAN filtering, this configuration will noticeably reduce the overall throughput. :global netControl “10.0.1.0/24 -the subnet your Sonos app is on" :global ifSonos “The interface Sonos speakers is connected to” :global ifControl “The interface your Sonos app is connected to”
Then you can configure PIM using the following config: Version and packages can be found by running /system package printĪrchitechture can be found by running /system resource print You can download it here choosing your current version and cpu architecture It turns out you need to add the multicast package to Mikrotik and reboot. This is because Sonos relies on UPNP and Multicast on address 239.255.255.250 which is not broadcasting over segmented nets. I was having an issue segmenting Sonos on a VLAN using Mikrotik.
0 kommentar(er)
